+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: How-To's (http://www.metalworkingfun.com/forum-8.html)
+--- Thread: A Novel Approach to Reading the Micrometer (/thread-1510.html)
Pages:
1
2
RE: A Novel Approach to Reading the Micrometer - Mayhem - 07-18-2013
(07-17-2013, 01:20 PM)TomG Wrote: It's been so long since I've used one the details are a little foggy. You could probably use the same approach, just with different coins.
Would it be dollars, fifty cent pieces and pennies...Darren?
I'll dust one off and take a look when I get home.
Tom
We have the following coins Tom: $2, $1, 50c, 20c, 10c and 5c
Now you know what you have to work with, I look forward to the metric version
RE: A Novel Approach to Reading the Micrometer - TomG - 07-18-2013
Maybe if you'll send me the change so I have some props, I'll consider it.
I think there is a metric mic around here somewhere...
RE: A Novel Approach to Reading the Micrometer - Mayhem - 07-18-2013
Here you go Tom:
[attachment=5686]
Just print and cut out...
RE: A Novel Approach to Reading the Micrometer - EdK - 07-18-2013
(07-18-2013, 07:31 AM)Mayhem Wrote: Here you go Tom:
Just print and cut out...
Is that dollar coin depicting a kangaroo orgy?
Ed
RE: A Novel Approach to Reading the Micrometer - Mayhem - 07-18-2013
That's nothing Ed - you should see what is on the 50c coin. I just couldn't show that side on a family oriented site such as this. That is why the Queen is showing in that picture.
RE: A Novel Approach to Reading the Micrometer - TomG - 07-18-2013
(07-18-2013, 07:31 AM)Mayhem Wrote: Here you go Tom:
Just print and cut out...
Darren you cheap b*****d!
RE: A Novel Approach to Reading the Micrometer - Highpower - 07-18-2013
(07-17-2013, 01:16 PM)DaveH Wrote: The first time I used a metric mic, I remember thinking, 'this is a bit odd....'
DaveH
'..... this mic wasn't off by a factor of 2.54 yesterday.'
