+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: a big D.T.I refit (/thread-1296.html)
Pages:
1
2
RE: a big D.T.I refit - doubleboost - 04-08-2013
Nice job
Way to small for my fingers
John
RE: a big D.T.I refit - stevec - 04-08-2013
"too small" John "too".
RE: a big D.T.I refit - krv3000 - 04-09-2013
thanks all for the comments john stop hitting them with the hammer then any way last bit it needed a end so i had a rummage and fawned this its a stand off used in computers to mount the curcet board i drilled the bottom out to 3.4 by 1.7 for a 3.5 ball to go in and put a angel on the front then drilled 1.6 for a m2 tap i mixed up sum epoxy and preset the ball in and screed in a length of 2mm studding left it to go hard then gave it a buff up right pics
RE: a big D.T.I refit - EdK - 04-10-2013
As always
Ed
RE: a big D.T.I refit - sasquatch - 04-10-2013
Agreed, great fix Bob.