+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: General Metalworking Discussion (http://www.metalworkingfun.com/forum-6.html)
+--- Thread: What insert type is this? (/thread-1247.html)
Pages:
1
2
RE: What insert type is this? - PixMan - 03-21-2013
Go to Carbide Depot.com's resource page and read up. Lots of great info there.
RE: What insert type is this? - Mayhem - 03-22-2013
Personally - if it were me, I'd buy a SCLCR holder, which takes CCMT/CCGT inserts as soon as I ran out of the inserts you are currently using. Toolmex are not expensive and a pretty good brand. As PixMan has stated, with this insert (80* rhomboid) you can turn and face without changing the holder. You can turn to a 90* shoulder too.