+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Billy G's Die Filer (/thread-2557.html)
RE: Billy G's Die Filer - Bill Gruby - 03-24-2015
Still no Bearing material. I am going to go with Naval Brass for now. There should not be enough heat generated by the linear motion to cause any problems. It's just too slow. One is done. The wife is sick again so my day is shot. Sometimes Life just gets in the way.
"Billy G"
RE: Billy G's Die Filer - Mayhem - 03-24-2015
Looking good Bill - I hope your wife is feeling better soon.
RE: Billy G's Die Filer - Bill Gruby - 03-24-2015
Mayhem;
I will have been married to Sophie for 45 years come April the 4th. She comes first, even over me.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-24-2015
She is sleeping so I finished these up. That was my goal for today.
"Billy G"
RE: Billy G's Die Filer - EdK - 03-24-2015
OK, I think I'm caught up with the changes now.
Ed
[attachment=10414]
RE: Billy G's Die Filer - Bill Gruby - 03-24-2015
Not yet Ed, you have one more then you are done. Sheet #8 -- The .750 offset of the pin should be 1.000. The Filer stroke is 2 inches, not 1.500.
"Billy G"
RE: Billy G's Die Filer - DaveH - 03-24-2015
(03-24-2015, 03:44 PM)Bill Gruby Wrote: Not yet Ed, you have one more then you are done. Sheet #8 -- The .750 offset of the pin should be 1.000. The Filer stroke is 2 inches, not 1.500.
"Billy G"
The .750" offset of the pin and because the pin is .5" dia will give a stroke of 2"
DaveH
RE: Billy G's Die Filer - Bill Gruby - 03-24-2015
OOOOOOOPS -- I forgot, we changed it to that. Thanks Dave. That means the prints are completed.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-25-2015
Stand down Ed, you're done. Thank you for the professional job. Again I apologize for all the errors that you had to correct. The frosting on the cake was this wooden yoke mock up. It dropped right in.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-26-2015
Linear Shafts are done. Alignment is right on.
"Billy G"