+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: 3D Printing (http://www.metalworkingfun.com/forum-46.html)
+--- Thread: Share your prints (/thread-4303.html)
RE: Share your prints - EdK - 04-19-2022
A box for the bits and bobs for tramming the mill. A dial indicator attaches to the end of the rod. I was storing them in a snack size zip lock bag which doesn't stack well.
Ed
[attachment=17852] [attachment=17853]
RE: Share your prints - EdK - 05-12-2022
I bought this tap guide back in about 2003. It was one of my first metalworking tools & I bought it at the J&L store in the Minneapolis area. Like most of the other retail metalworking suppliers, they got bought by MCS and were shut down. Same as the Enco retail stores.
The tap guide has been stored in the plastic pouch since the day I bought it. The tongue on it is about ready to fall off so I decided it was time to make a new home for it.
Ed
[attachment=17895] [attachment=17896]
RE: Share your prints - JScott - 05-13-2022
Very nice and really like the label ID on the side.
RE: Share your prints - Highpower - 05-17-2022
RE: Share your prints - Mayhem - 05-18-2022
(05-12-2022, 09:09 AM)EdK Wrote: I bought this tap guide back in about 2003. It was one of my first metalworking tools & I bought it at the J&L store in the Minneapolis area. Like most of the other retail metalworking suppliers, they got bought by MCS and were shut down. Same as the Enco retail stores.
The tap guide has been stored in the plastic pouch since the day I bought it. The tongue on it is about ready to fall off so I decided it was time to make a new home for it.
Ed
I thought you might have printed a new pouch in flexible filament
RE: Share your prints - EdK - 05-20-2022
Storage for the change gears for the mini lathe.
Ed
[attachment=17898] [attachment=17899]
RE: Share your prints - vtsteam - 05-20-2022
I like that, and I'm not a 3DPrinter guy. But nice design, very neat and compact, and I like the color, too. Very nice!
RE: Share your prints - EdK - 05-21-2022
It sure is dead around here so you people are stuck with my 3D printed box posts.
This time one for my angle plates. The cardboard box they were stored in started deteriorating so I made them a new home.
Ed
[attachment=17900] [attachment=17901]
RE: Share your prints - EdK - 05-22-2022
I got these small v-blocks yesterday from Travers Supply. They came in a plastic bag type mailer so the box they came in was trashed and the parts were banging around inside the bag. They needed a new home since their old one was abused beyond use.
Ignore the upside down text. I can still read it so it stays.
Ed
[attachment=17902]
[attachment=17903] [attachment=17904]
RE: Share your prints - rleete - 05-23-2022
My OCD demands you fix that and reprint it.