+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: Projects (http://www.metalworkingfun.com/forum-7.html)
+--- Thread: Billy G's Die Filer (/thread-2557.html)
RE: Billy G's Die Filer - DaveH - 03-11-2015
The Bearing Block (sheet 11) gives the centre (of vertical movement) as 1.5". Base to centre of hole
The Yoke Guide (sheet 15) gives the centre (of vertical movement) as 1.625". Base to centre of the .25" groove
There is a miss alignment of .125"
DaveH
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
That is not a misalignment. It is for clearance with the crank.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
Ed;
This is the slot I was talking about. The stud fits thru and pulls the Trunnion down locking it at a specific angle. It gave me the fits last night (Water Heater didn't help either) I just couldn't picture it. Now I can and will.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
Dave;
Disregard my post on the alignment. I need to take another look at it. It looks like you are correct. Yup, you are. Ed, on the Yoke Guide make the height 1.875 instead of 2.000. That will make up for the error. Dave, yer battin 1000.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
One right side, one left side. Only mounting left on these.
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
Where is "Doubleboost" I haven't seen him on lately?
"Billy G"
RE: Billy G's Die Filer - EdK - 03-11-2015
(03-11-2015, 03:59 PM)Bill Gruby Wrote: Where is "Doubleboost" I haven't seen him on lately?
"Billy G"
He was on 3 hours ago.
Ed
RE: Billy G's Die Filer - EdK - 03-11-2015
(03-11-2015, 12:26 PM)Bill Gruby Wrote: Ed;
This is the slot I was talking about. The stud fits thru and pulls the Trunnion down locking it at a specific angle. It gave me the fits last night (Water Heater didn't help either) I just couldn't picture it. Now I can and will.
"Billy G"
OK, much clearer now.
I'm getting behind on the changes. Good thing they are documented in this thread.
Ed
RE: Billy G's Die Filer - Bill Gruby - 03-11-2015
Take your time Ed. As you said earlier, "They will be complete and easy to follow when finished."
"Billy G"
RE: Billy G's Die Filer - Bill Gruby - 03-12-2015
Good Morning Ed;
Sheet 2 of 15 (Back Plate) the ten .170 clearance holes need to be changed to .257, clearance for 1/4-28 screws. These are for the three Bearing Blocks and the two Yoke Guides.
"Billy G"