+- MetalworkingFun Forum (http://www.metalworkingfun.com)
+-- Forum: Machining (http://www.metalworkingfun.com/forum-5.html)
+--- Forum: 3D Printing (http://www.metalworkingfun.com/forum-46.html)
+--- Thread: Share your prints (/thread-4303.html)
RE: Share your prints - EdK - 02-14-2022
(02-13-2022, 11:49 PM)Vinny Wrote: How long before the label start falling off?That's my concern with stick on labels. It gets real hot down here so I don't think they'd last very long.
Ed
RE: Share your prints - Highpower - 02-14-2022
(02-14-2022, 05:30 AM)arvidj Wrote: Willie,
Was that with the Brothers Extra Strength Adhesive labels?
No Arvid, I have older Brother printer models that use TZ labels that pre-date the newer TZe tapes with 'extra' adhesive. So far I've only been using the 'standard' labels in my new Epson printer to see how well they hold up. Right out of the gate I can tell they are 2 or 3 times more sticky than the older Brother standard TZ labels. I do have a box full of the extra strength adhesive Epson labels at the ready - just in case. So far the standard strength labels are doing a good job of holding on, but I'm still early on in the longevity testing phase.
RE: Share your prints - Highpower - 02-14-2022
(02-14-2022, 08:08 AM)rleete Wrote: The biggest disappointment to me was that the labels are like store receipt paper. Not glossy at all.
We'll see how long they last.
I'm guessing you are using the paper labels?
The plastic labels should be glossy, and maybe stronger adhesive too?
RE: Share your prints - rleete - 02-14-2022
Yes, the paper ones. It's the stuff it came with. It never occurred to me it wasn't plastic.
RE: Share your prints - Dr Stan - 02-14-2022
(02-14-2022, 01:40 AM)Highpower Wrote: Usually less than a year. Some only lasted a month or two on painted steel G.I. ammo cans. And I've had a couple that fell off within an hour depending on the surface it was being stuck to. Plastics like blow molded tool cases were the worst. Cleaning everything with IPA before applying the labels didn't help any. The adhesive just wasn't very tacky at all.
IPA India Pale Ale?
RE: Share your prints - Vinny - 02-15-2022
This is what I use. Looking over at the drawers I see a couple with the corners lifting but the rest have been on those drawers for years.
[attachment=17735]
First time I used an attachment in a long time. Not very intuitive, is it?
RE: Share your prints - Highpower - 02-16-2022
(02-15-2022, 11:39 PM)Vinny Wrote: First time I used an attachment in a long time. Not very intuitive, is it?
I remember the old Dymo embossed labels would shrink and curl up over time and tear themselves loose. They all ended up on the floor in perfect little circles. I guess they were made out of some kind of 'memory' plastic, and wanted to return to it's original coiled up state.
RE: Share your prints - EdK - 04-07-2022
Here we go again, another box.
This time for my edge finders.
Ed
[attachment=17842]
RE: Share your prints - EdK - 04-12-2022
And yet another box.
Ed
[attachment=17849]
RE: Share your prints - Vinny - 04-13-2022
That looks real good!