Expectations of a granite surface plate ...
|
Expectations of a granite surface plate ...
|
03-06-2012, 03:56 PM
(03-06-2012, 03:48 PM)ETC57 Wrote: Ok so why when I take a crew out to install a rather large (4'x8') surface plate in R&D type shops the customer always make me get out the machinist level? The customer wants it level. Like arvidj has indicated it can be useful to know that it is level. For inspection purposes the surface plate is nearly always set level and checked often.  DaveH 
03-06-2012, 04:07 PM
(03-06-2012, 03:56 PM)DaveH Wrote:(03-06-2012, 03:48 PM)ETC57 Wrote: Ok so why when I take a crew out to install a rather large (4'x8') surface plate in R&D type shops the customer always make me get out the machinist level? So it's have your cake and eat it to!  Jerry.  
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
 (03-06-2012, 03:51 PM)DaveH Wrote:(03-06-2012, 03:44 PM)arvidj Wrote: I understand the difference between level and flat. No apology necessary. I think you may have taken the tone of the message incorrectly i.e. is was not intended to sound like your wife telling you what she knows when you try to explain something to her just me stating a fact and then an example of what I was wanting to do ... but obviously will not be able to accomplish. 
03-06-2012, 04:50 PM
Hi
I have had a large piece of marbel in my shop for months now I had to move it and it broke I now have a piece 24 inch by 16 inch Checking it for flatness i found it to be well within 1 thou (plenty good enough for what i do) I have a 8/10 ground iron plate but this is a bit small for the stuff i make John
03-06-2012, 04:53 PM
03-06-2012, 04:56 PM
Funny that is what the wife said
It was 6 feet long 18 inches wide 1 1/2 inches thick stupidly heavy and millions of years old I was going to blame the plumer but did not have the heart to John
03-06-2012, 05:04 PM
03-06-2012, 05:12 PM
Arvid, I hope your questions have been answered, Sometimes the jocularity obscures the legitimacy.
You've had one reply that "One side will be ground flat and the other is usually kind of rough." Is your plate like so? (I doubt you would have asked the question if it were blatantly obvious). The other point of parallelism you've answered yourself and I agree. So, to reiterate, because I'm curious, are some surface plates ground to the same flatness and surface precision on both sides?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Steve,
to answer your question from my experience some of the plates I have installed have been finished on both sides Jerry.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
03-06-2012, 05:27 PM
Hi
I think it would be a good idea to have both surfaces ground If one surface gets damaged it could be turned over and the other side used. John |
|
« Next Oldest | Next Newest »
|
