|
Wire clamp tool...
|
08-16-2012, 07:09 AM
Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF
claudef, proud to be a member of Metalworking Forum since Mar 2012.
08-16-2012, 09:36 AM
(08-16-2012, 07:09 AM)claudef Wrote: Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.  It sure looks like it works well. Tight and tidy clamps. 
Willie
|
|
« Next Oldest | Next Newest »
|
