MetalworkingFun Forum › Machinery › Lathes › Lathe Tooling v
Too good to be true?

Thread Modes
Too good to be true?
Charles Spencer Offline
Freshman
**
Posts: 41
Threads: 1
Joined: Aug 2014
Location: Massachusetts
#21
11-23-2015, 06:32 AM
(11-19-2015, 12:22 AM)Roadracer_Al Wrote: Does anyone have any experience with this 5-pack of tool holders?

http://www.amazon.com/dp/B00S55J8D2/ref=...GYMCHZU4SZ

I've been wanting new tool holders, and these seem like an impossibly low price -- I don't think I can buy the material for that.  Same seller also offers 10 holders for $200, which would probably be just plain gratuitous.

I figure that if they're too soft and getting buggered up, I can always case harden them.

If you buy the tool holders from Shars, they say ""Shars" where the others say "Made in China".

It doesn't change anything but at least it's not in your face all day long.
Charles Spencer, proud to be a member of MetalworkingFun Forum since Aug 2014.
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#22
11-23-2015, 07:54 AM
A cheap rattle can also removes the Made in China...
Hunting American dentists since 2015.
Reply
Thanks given by:
Highpower Offline
JAFO
******
Posts: 4,452
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
The following 2 users Like Highpower's post:
Mayhem (11-23-2015), EdK (11-23-2015)
#23
11-23-2015, 08:31 AM
(11-23-2015, 06:32 AM)Charles Spencer Wrote: If you buy the tool holders from Shars, they say ""Shars" where the others say "Made in China".

Maybe "Shars" means "China" in Mandarin? Chin

Rotfl
Willie
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#24
11-23-2015, 09:03 AM
Being a QCTP you may be able to take the Apple stance and say made in China, assembled in [add your state here]...
Hunting American dentists since 2015.
Reply
Thanks given by:
Roadracer_Al Offline
Junior
****
Posts: 691
Threads: 14
Joined: Feb 2015
Location: Oakland, California
#25
11-23-2015, 06:17 PM
Dang, Vinnie, you're my hero!
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)