03-19-2015, 04:53 PM
|
A Boma
|
03-19-2015, 04:59 PM
And these,
Perfect she said   DaveH
03-19-2015, 05:13 PM
That looks like a waste basket to me.
 Ed
03-19-2015, 05:30 PM
03-19-2015, 05:39 PM
I'm not too keen on them, the paint burns off, then they go rusty and look a mess.
Stainless steel - too expensive. DaveH
03-19-2015, 06:04 PM
A stainless steel one may look nice.
DaveH
03-19-2015, 06:34 PM
Might be a reason to buy a spot welder for the stainless.
Then when it will only do up to 1/8", you could say, you need to rivet it in thicker stock for safety reasons, so send for some stainless rod. When that causes you to hit your thumb (just use some purple and black magic marker) tell her a TIG rig is too expensive, mybe you should just give up........unless?
03-19-2015, 06:54 PM
Riveting - that's too many holes to drill
 DaveH
03-19-2015, 06:57 PM
Good point -- add that to the list of problems that will get you a TIG in the end.....
03-19-2015, 07:02 PM
I'm trying to find out if I can just stick weld it?
http://metalworkingfun.com/showthread.php?tid=2590 DaveH |
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 9 Guest(s)