Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
What is the life expectancy of one of those taps Ken?
Hunting American dentists since 2015.
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
That depends upon the material, the depth of the hole, the cutting speed used, etc.
For an example, I used the (free) GPS software on the Walter website and entered 1018 steel, 1.5" deep. With that I get 410rpm, 6.3 seconds per hole, expect at least 487 holes.
If I change the material to 316 stainless steel and go only 1" deep, it suggests 127rpm @ 13.44 seconds per hole but only 141 holes. In my experience with the THL coating you generally get 3 to 4 times those number of holes when using a tapping compound. The whole point of using the THL coating is that for most CNC machines you can't (or do not want to) stop mid-cycle for a dab of tapping fluid so you run with machine coolant. That's where you see the software predicted life getting closer to reality.
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
So I'm guessing that you will never wear it out then
I'm surprised that the CNC machines don't have an attachment that puts a dab of cutting fluid on the tap. They seem to be able to do everything else.
Hunting American dentists since 2015.
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
What some shops do is have a lube attachment that will spray a low viscosity lube at the tap, others will have a cup mounted off to the side (out of the coolant stream) and program the tool to move to it and dip the tip in paste. That's wasteful and usually far too much lube.
And you're right, I expect that tap to be an "heirloom" tool, right along with my measuring tools.
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
Technically not UPS, but....
If there is an "after-life" I want to come back as a machine tool manufacturer. I used to complain about the price of mechanics tools, but no more!
$160 Really!!!???
Willie
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
Ed
Posts: 736
Threads: 34
Joined: Feb 2012
Location: Minneapolis, MN
The following 1 user Likes arvidj's post:
EdK (01-15-2015)
Willie, I no longer feel bad about the cost of my welder repair. On a per pound basis i think I came out way ahead!!!
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
(01-15-2015, 07:39 PM)arvidj Wrote: Willie, I no longer feel bad about the cost of my welder repair. On a per pound basis i think I came out way ahead!!!
You might be right about that Arvid.
Although pound for pound I think your welder is only about 25 lbs heavier than the transformer in my Syncrowave.
The scary thing is Enco's "Made in America" (mystery manufacturer) brand feelers would have only been about $5 less.
I'd rather buy direct from the manufacturer and know what I'm getting for the extra fin.
Willie
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
(01-15-2015, 10:11 PM)Highpower Wrote: ...
The scary thing is Enco's "Made in America" (mystery manufacturer) brand feelers would have only been about $5 less.
...
Plus they don't say which America they are made in.
Ed
