Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
Quite a wile ago now I saved a old Colchester lathe dated 1918-1919 its been in a barn for 20 years left to rust
Just thought it may be of interest to some members
Anyway here is a link to the before and after with a lot of TLC
http://thesquattersarms.proboards.com/th...ster-lathe
mfletch, Try to do the best you can and that's good enough
Posts: 332
Threads: 10
Joined: Nov 2012
Location: East Yorkshire
Fabulous work, and I bet you enjoyed it too. Don't knock it till you've tried it, I bet that old girl is more accurate than you think. Accuracy is a matter of knowing your machine and sneaking up on finished size before it notices you are there! I have a MK1 colchester student, and a Covmac that is very much like that machine! I wait with baited breath for the video of you making swarf with it!
Phil, East Yorks.
Posts: 638
Threads: 43
Joined: Sep 2012
Location: England
Looks likecyou have made a cracking job there
It now looks like it was cared for from new, rather than neglected then refurbished. Did you just paint various bits and clean up paintwork where posible.
Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Posts: 332
Threads: 10
Joined: Nov 2012
Location: East Yorkshire
Did you strip it down, or just clean it as it stood there? Whichever you have made a fantastic machine out of it, and TBH it doesnt look to have had that much use. I really like the colour, I am a real sucker for red stuff!
Phil
Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
The following 1 user Likes mfletch's post:
stevec (08-05-2014)
I took off the tailstock and compound slide plus the cross slide
I just cleaned the bed ways little by little only moving the saddle onto clean oiled ways until all was clean hours and hours but loved every minute
mfletch, Try to do the best you can and that's good enough
Posts: 8,888
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota
That cleaned up very nicely. Good rescue!
Ed
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
Good job Fletch looks good as new.
DaveH
Posts: 2,328
Threads: 271
Joined: Jun 2014
Location: La Libertad, Philippines
Posts: 79
Threads: 12
Joined: Dec 2013
Location: mansfield UK
(08-09-2014, 11:35 AM)Dr Stan Wrote: That's gorgeous!
Cheers Stan
mfletch, Try to do the best you can and that's good enough
Posts: 313
Threads: 34
Joined: Nov 2013
Location: Kamloops, BC, Canada
Beautiful job
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
