Making A Welding Table

Pages (11): « Previous 1 2 3 4 5 6 7 8 9 ... 11 Next »

Thread Modes

Making A Welding Table

DaveH

Child of the 60's

Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa

#41

09-23-2013, 01:24 PM (This post was last modified: 09-23-2013, 01:26 PM by DaveH.)

Thinking something like this.

The drawers can go in the sides, the bottom rails can be used as a support for a 'shelf'
It will be a lot stronger and stiffer than having a centre support.

That's my thinking done for the day Big Grin

DaveH

PS. The colour looks good Rotfl

Like Post

EdK

Whipping Boy

Posts: 8,888
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota

#42

09-23-2013, 05:20 PM

(09-23-2013, 11:50 AM)stevec Wrote: Ed, I don't think the "doubling" of the front rails nor the 45° bracing are at all necessary.
But then I don't know the Tonnage of capacity required..
...

Steve,

I'm thinking the same. After all we're talking about only a couple of hundred pounds of load distributed over the frame. 17428

Like Post

EdK

Whipping Boy

Posts: 8,888
Threads: 320
Joined: Feb 2012
Location: Arizona/Minnesota

#43

09-23-2013, 05:23 PM

(09-23-2013, 01:24 PM)DaveH Wrote: Thinking something like this.

The drawers can go in the sides, the bottom rails can be used as a support for a 'shelf'
It will be a lot stronger and stiffer than having a centre support.

That's my thinking done for the day

DaveH

PS. The colour looks good

Dave,

You may be right but is that necessary for the weight this bench is going to see? I don't mind over engineering to an extend for safety but when does it become overkill? Chin

I certainly don't want to discourage discussion about this. One can't have too much information when making a decision.

Ed

Like Post

DaveH

Child of the 60's

Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa

#44

09-23-2013, 06:27 PM

Ed, it was really an alternative suggestion to using those mid vertical pieces and doubling up on the bottom rail.
Also if it was a stationary bench then I wouldn't bother with the 45deg bracing.

I'll take a photo of my heavy duty bench just to show I do practice what I preach Big Grin

DaveH

Like Post

Thanks given by: EdK

stevec Offline

69 yr. old senior

Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada

#45

09-23-2013, 06:52 PM (This post was last modified: 09-23-2013, 06:52 PM by stevec.)

(09-23-2013, 05:23 PM)EdK Wrote: One can't have too much information when making a decision.
Ed

Actually Ed, one can have too much information. Dave's table serves his purpose mine serves mine. I can't imagine ever putting a weight load on it that would cause it to fail but I'm sure there exists a load that'll test it.
In the end, you'll decide and it'll work for you. Worthy