MetalworkingFun Forum › Machining › General Metalworking Discussion v
Craigs List ... not sure if it was worth it or not

Thread Modes
Craigs List ... not sure if it was worth it or not
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#11
04-28-2013, 09:15 PM
Don't think you made out too bad? The Albrecht chuck alone is $360 new.

The cast iron plates aren't surface plates, they are lapping plates.

Oh...and You Suck

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Tony Wells Offline
Sophmore
***
Posts: 200
Threads: 4
Joined: Feb 2012
Location: Tyler, TX USA
#12
04-28-2013, 11:37 PM
You did better than good. If you can't triple your money and keep everything you want, I'll eat my hat.
Reply
Thanks given by:
Mayhem Offline
purveyor of mischief
******
Posts: 4,683
Threads: 93
Joined: Feb 2012
Location: Perth, Australia
#13
04-29-2013, 05:23 AM
(04-28-2013, 11:37 PM)Tony Wells Wrote: You did better than good. If you can't triple your money and keep everything you want, I'll eat my hat.

Now I would pay good money to see that! Don't you wear big hats down south?
Hunting American dentists since 2015.
Reply
Thanks given by:
EdK Offline
Whipping Boy
*******
Posts: 8,854
Threads: 318
Joined: Feb 2012
Location: Arizona/Minnesota
#14
04-29-2013, 05:59 AM
(04-28-2013, 07:16 PM)f350ca Wrote: ...
Ed they go to Boot sales for the same reason people here go to Flea markets with no intention of buying fleas, and I scoured garage sales looking for a two car one but had no luck.

Good points Greg. Chin

Ed
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)