|
a big D.T.I refit
|
hi all i got this today it just needed my loving touch in all it is OK a part from the mane shaft so it got striped dawn in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
04-07-2013, 05:48 PM
sos i left sum pics out
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
04-07-2013, 06:11 PM
once a part their was two things that needed downing one repairing the plunger rod two reaper the base cover i reaped the plunger rob by cutting the end off and drilling 1.6mm by 6 deep then taping with a m2 tap i then made a new bottom length of rod and drilled both ends 1.6mm by 6 deep then taped them m2 then with sum Bering fit and a length of m2 studding i jond the two together as for the back i just cleaned up the part that sum one had made before and silver soldered it to the back right pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
 
04-07-2013, 06:58 PM
04-08-2013, 06:37 AM
(04-07-2013, 05:40 PM)krv3000 Wrote: in pic 3 you will see the notch cut out in the bezel to remove the retaining ring once this was out it all came a part with ease and all was given a good scrub up  ( Yawn, Ho Hum)I still haven't found the "notch". The bezel is the "glass" right?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
04-08-2013, 02:58 PM
Darren, is it easier to see things "down under"?
Thanx man! 
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
04-08-2013, 03:04 PM
Hi Bob , another quality fix
 , you must be able to take them things apart in your sleep now  , I am not really a clumsy person but looking at them photos of fine springs etc I know if it was me there would not be a happy ending lol  Keep up the good work Bob , Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
|
|
« Next Oldest | Next Newest »
|
