So i fired up my lathe and chucked up a chunk of round scrap that i keep for small projects. It needed to have a 1 1/8" hole punched in the gasket. So i turned the chunk to 1 1/8" OD then turned the compound and cut from the center out making a nice sharp edge for the cutter. I left a small bump in the center of the punch to line up with the punch mark that i made with an ice pick down thru the diaphram cover. Just lined up the punch mark and slid everything in my shop press and punched it out. Perfect. 5 minute job....Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
(09-23-2012, 02:36 PM)aametalmaster Wrote: So i fired up my lathe and chucked up a chunk of round scrap that i keep for small projects. It needed to have a 1 1/8" hole punched in the gasket. So i turned the chunk to 1 1/8" OD then turned the compound and cut from the center out making a nice sharp edge for the cutter. I left a small bump in the center of the punch to line up with the punch mark that i made with an ice pick down thru the diaphram cover. Just lined up the punch mark and slid everything in my shop press and punched it out. Perfect. 5 minute job....Bob
It makes you wonder how people manage with out a lathe
John
I'm thinking a couple of hours start to finish, but the Cherrio's box he made it from is probably better material then the one he could of purchased for 30 cents.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
09-23-2012, 07:34 PM (This post was last modified: 09-23-2012, 07:38 PM by NevadaBlue.)
Nice work!
You make a gasket like that without a lathe by using a gasket hammer. I still have one of the tiny ball-pein gasket hammers, I think the head is about an inch long.
This pic is from the internet, but I have a hammer quite a bit smaller than this one.
You make a gasket like that without a lathe by using a gasket hammer.
Still kickin it old school, eh Ken?
I've done that plenty of times for pump housings, water necks, some manifolds, etc. I don't know that I would want to do it on a carburetor body though.
I'm surprised that Bob didn't have 100 of those gaskets sitting on a shelf somewhere though.
You make a gasket like that without a lathe by using a gasket hammer.
Still kickin it old school, eh Ken?
I've done that plenty of times for pump housings, water necks, some manifolds, etc. I don't know that I would want to do it on a carburetor body though.
I'm surprised that Bob didn't have 100 of those gaskets sitting on a shelf somewhere though.
Aw Willie ya gotta live on the edge.I've made hundreds of carb gaskets with a hammer, motorcycles engine cases as well ya just gotta tap lite!!
Jerry.
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
I'm callin ya on that Bob.
![[Image: bmwr512m.jpg]](http://www.benchmarkworks.com/restoration/bmwr512r2_files/bmwr512m.jpg)
